MITSUBISHI HS-MF23-S2A AC Servo motor 200W

Buy online this AC Servo Motor MITSUBISHI HS-MF23-S2AIntelligent Servo Motor  (HSMF3EXVS2) belonging to the HS-MF23 range of MITSUBISHI motors and to the MITSUBISHI With amplifier/encoder for NC system, available on Cnc-shopping. The MITSUBISHI HS-MF23-S2A AC servomotor with straight shaft at a nominal rotation speed of 3000 rpm and with a power of 200W. The MITSUBISHI HS-MF23-S2A, powered is equipped with a measurement system type 8,000/absolute value encoder. This MITSUBISHI HS-MF23-S2A axis motor can be connected through its power plug and feedback encoder plug with cables mounted in front. This MITSUBISHI HS-MF23-S2A motor is ready to replace your old or faulty MITSUBISHI HS-MF23-S2A servomotor installed on your CNC machine-tools and is sold with a functional warranty.

Our MITSUBISHI HS-MF23-S2A motors are fully tested by our technicians according to manufacturer's procedures. 

Connect the HS-MF type relay connector in a relay box having a structure (IP54) that prevents the entry of water, oil and dust, etc. Fix the enclosed cable to the motor. When the motor shaft is turned by hand, it may seem heavier than other servomotors, or may seem tight. This is caused because of the dynamic brakes in the built-in amplifier, and is not a fault.

Fully closed self-cooling: Protective structure IP65 (Excluding MF23 connector. Protection applies for all connectors when engaged to machine.) 

The MITSUBISHI HS-MF23 does not have a built-in regenerative resistor. Thus, there are limits to the instantaneous regeneration capacity. Avoid use in which the regeneration occurs continuously, such as with a vertical axis. When using the motor in the left range of the graph on the right, there are no limits to the regeneration frequency. When used in the right range, an overvoltage alarm could occur, so avoid using in this range.